Hobie Forums
http://www.hobie.com/au/en/forums/

Pre-drilled mount size?
http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=53746		 Page 1 of 1
Author:  sean6t4 [ Tue Jan 20, 2015 12:27 pm ]
Post subject:  Pre-drilled mount size?
Hey All :D

I was wondering if anyone knows what size screws fit the pre-drilled holes for the anchor trolley system on a PA-12?
Author:  Dr.SteelheadCatcher [ Tue Jan 20, 2015 10:35 pm ]
Post subject:  Re: Pre-drilled mount size?
My 2013 PA-14 uses 10-32 x 1/2" deep brass inserts......I would assume Hobie has not changed these inserts as the anchor trolley is the same device/unchanged.
Author:  BadKarma [ Wed Jan 21, 2015 12:32 am ]
Post subject:  Re: Pre-drilled mount size?
Dr.SteelheadCatcher wrote:
My 2013 PA-14 uses 10-32 x 1/2" deep brass inserts......I would assume Hobie has not changed these inserts as the anchor trolley is the same device/unchanged.




Thats correct. I used that size on my 2015
Author:  sean6t4 [ Wed Jan 21, 2015 3:57 pm ]
Post subject:  Re: Pre-drilled mount size?
Great! Thanks Guys! 8)
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/