| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Pro Angler Seat Question http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=55922 |
Page 1 of 1 |
| Author: | Yak4Food [ Sun Sep 06, 2015 7:25 am ] |
| Post subject: | Pro Angler Seat Question |
I purchased a Pro Angler 14 without a seat. The hull is in new condition. I do not have the base or anything except the bare hull. I was wondering if anyone had some ideas of how the rig a seat . Thanks |
|
| Author: | Dr.SteelheadCatcher [ Sun Sep 06, 2015 7:47 am ] |
| Post subject: | Re: Pro Angler Seat Question |
What year is the PA? |
|
| Author: | Yak4Food [ Sun Sep 06, 2015 8:41 am ] |
| Post subject: | Re: Pro Angler Seat Question |
2012 |
|
| Author: | Dr.SteelheadCatcher [ Sun Sep 06, 2015 10:14 am ] |
| Post subject: | Re: Pro Angler Seat Question |
Go to PDF page 58 which is catalog page 56 to see what the Hobie P/N's are. http://cdn.hobiecat.com/digital_assets/ ... atalog.pdf The seat and parts will be over $300. I assume the rudder control is already installed....if not, you need to order those parts too. |
|
| Author: | Yak4Food [ Sun Sep 06, 2015 12:14 pm ] |
| Post subject: | Re: Pro Angler Seat Question |
The rudder is installed. I was looking on doing this with after market parts without hobie parts as believe there may be easier solutions |
|
| Author: | saltfisherman [ Sun Sep 06, 2015 3:05 pm ] |
| Post subject: | Re: Pro Angler Seat Question |
Cabelas has a universal seat slide and add any padded bass boat style seat. The slide works great. It will match up to kayak mounting and padded seat bolts to it. I did this to my older style PA and it was very comfortable. I no longer have the PA air I'd be able to get a pic to you. You should find info by Googling PA seat slide. It will give you model numbers too. I just did a quick look and you need the original seat mounting from the PA to make this slide work. |
|
| Author: | Android77 [ Thu Sep 10, 2015 8:38 am ] |
| Post subject: | Re: Pro Angler Seat Question |
The seat mount is only 2 pieces of 3" x 1 1/2" aluminum channel. Sent from my iPhone using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|