OR, after removing the fin,you can try straightening the mast without taking it off. for most bends that works fine.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Bent md 180 http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=59396 |
Page 1 of 1 |
| Author: | Bawitheba [ Thu Oct 27, 2016 12:37 pm ] |
| Post subject: | Bent md 180 |
I beached my pro angler today. How do I get the mast out so I can change it out? |
|
| Author: | Jbernier [ Thu Oct 27, 2016 12:59 pm ] |
| Post subject: | Re: Bent md 180 |
Remove the fin (un-srew the adjuster screw on the rear of the fin) then take it out and put the mast in a vise (the mast has a notch on near the tip so you can grab it with a wrench and unwind it) |
|
| Author: | Roadrunner [ Thu Oct 27, 2016 7:22 pm ] |
| Post subject: | Re: Bent md 180 |
OR, after removing the fin,you can try straightening the mast without taking it off. for most bends that works fine.
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|