| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Bimini Top http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=60658 |
Page 1 of 1 |
| Author: | Curtis in Cape Cod [ Tue May 30, 2017 11:12 am ] |
| Post subject: | Bimini Top |
I'm looking for a bimini top for our two Pro Anglers (12&14). All of the small ones seem to be too wide. |
|
| Author: | mmiller [ Tue May 30, 2017 11:33 am ] |
| Post subject: | Re: Bimini Top |
Did you look at Pro-Techt? https://www.pro-techt.com/index.php/mantis-junior-pro-plus.html |
|
| Author: | Curtis in Cape Cod [ Tue May 30, 2017 4:25 pm ] |
| Post subject: | Re: Bimini Top |
I did. It used to be sold by Hobie, right? I also looked at the umbrella types. Classic bimini style is the way to go. With a rail fitting, it would be great. Nothing like some shade. |
|
| Author: | mmiller [ Tue May 30, 2017 4:55 pm ] |
| Post subject: | Re: Bimini Top |
Yes, we had the Jr Pro. They sell our mount design now. We only stopped selling because the supply volume from them to us was inconsistent. It's a good product. |
|
| Author: | Curtis in Cape Cod [ Sat Jun 03, 2017 9:57 am ] |
| Post subject: | Re: Bimini Top |
Thanks. |
|
| Author: | patgrahamyak [ Tue Jun 11, 2019 8:30 am ] |
| Post subject: | Re: Bimini Top |
Hi there, I was doing some research and found this thread. We have a mirage oasis (tandem) and trying to figure out if we can install two Pro-Techt Junior Pro Plus biminis on our kayak. Has anyone done that and if so, what hardware did you use? |
|
| Author: | mmiller [ Tue Jun 11, 2019 3:02 pm ] |
| Post subject: | Re: Bimini Top |
Quote: we had the Jr Pro in the past. They sell our mount design now. https://www.pro-techt.com/mantis-mounts/kayak-mount.html |
|
| Author: | Clay34 [ Fri Jun 14, 2019 11:35 am ] |
| Post subject: | Re: Bimini Top |
Will these move out of the way easily so that you can stand and cast? I fish a lot standing. |
|
| Author: | patgrahamyak [ Fri Jun 14, 2019 11:49 am ] |
| Post subject: | Re: Bimini Top |
Thanks for the reply. We were hoping to use the Yak Attack system to make it easier to attach and remove the system but it doesn't appear it will work because we can't get into the hull. https://www.pro-techt.com/index.php/kay ... re=default Has anyone done this successfully? I thought there were some threads in this forum about the pro-techt product but can't find them now. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|