Hobie Forums
http://www.hobie.com/au/en/forums/

Foam Placement
http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=60688		 Page 1 of 1
Author:  DWDrummer13 [ Sat Jun 03, 2017 1:28 pm ]
Post subject:  Foam Placement
Hello Everyone: I need a diagram for the foam placement on a PA 14 2014. Mice got into my PA and I had to blow the inside of the hull out with water. Nasty mice. 1 got stuck on a drain hole.
Thanks
Hans
Author:  riverfish [ Mon Jun 05, 2017 6:44 am ]
Post subject:  Re: Foam Placement
Here is a diagram of a 12ft. ProAngler if it helps, it should be similar to a 14ft.
Image
Author:  AKRuss [ Sun Jun 25, 2017 4:59 pm ]
Post subject:  Re: Foam Placement
I added 10 swimming noodles to my 2015 PA 14 for extra buoyancy. I capsized once and my kayak shipped so much water it wasn't operable once I got back on top.
Author:  Dr.SteelheadCatcher [ Mon Jun 26, 2017 8:51 pm ]
Post subject:  Re: Foam Placement
Carrying a hand operated bilge pump is cheap insurance :mrgreen:
Author:  AKRuss [ Tue Jun 27, 2017 12:58 pm ]
Post subject:  Re: Foam Placement
Yes, I now carry a hand operated bilge pump, a plastic bailer (plastic pitcher), 10 swimming noodles for added floatation, and, most importantly, know how to get my PA 14 back upright in deep water and how to get back in. When I capsized, it took me 45 minutes to get the kayak upright as I couldn't find any water shallow enough to get my feet on the bottom and I didn't know any other technique. Live and learn - any luck at all.
Author:  68camaro [ Mon Jul 03, 2017 4:06 am ]
Post subject:  Re: Foam Placement
Do you stuff the noodles inside or lash to top?
Author:  Dr.SteelheadCatcher [ Mon Jul 03, 2017 9:17 pm ]
Post subject:  Re: Foam Placement
Stuff inside......
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/