| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Power Pole Mount http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=62971 |
Page 1 of 1 |
| Author: | basscatlildave [ Fri Jun 15, 2018 6:02 am ] |
| Post subject: | Power Pole Mount |
I just put a Micro Power Pole on my 2016 PA-14. The Hobie mount don't fit the the contour very well. It says remove the rudder cable cover plate and bolt down the power pole plate but it leaves gaps on the sides. Has anybody ran into this? |
|
| Author: | SRAces [ Fri Jun 15, 2018 2:23 pm ] |
| Post subject: | Re: Power Pole Mount |
basscatlildave wrote: I just put a Micro Power Pole on my 2016 PA-14. The Hobie mount don't fit the the contour very well. It says remove the rudder cable cover plate and bolt down the power pole plate but it leaves gaps on the sides. Has anybody ran into this? That's normal. It does not sit flush against the top of the hull. No worries. 
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|