| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| installing hummingbird XHS 9 HDSI 180 T transducer http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=65007 |
Page 1 of 1 |
| Author: | Clay34 [ Sun Jun 23, 2019 7:15 pm ] |
| Post subject: | installing hummingbird XHS 9 HDSI 180 T transducer |
I have a 2019 PA 14 with the Guardian transducer mounting plate. I found the Guardian transducer mounting templates on the Hobie website. I also tried to find something on YouTube. Nothing on this transducer. I would like to do it the right way. Any pushes in the right direction would be appreciated. |
|
| Author: | wjPA1415 [ Sat Jul 06, 2019 3:58 pm ] |
| Post subject: | Re: installing hummingbird XHS 9 HDSI 180 T transducer |
https://www.mariner-sails.com/berleypro ... -mount.htm Look up berleypro |
|
| Author: | Clay34 [ Sun Jul 07, 2019 10:39 am ] |
| Post subject: | Re: installing hummingbird XHS 9 HDSI 180 T transducer |
wj, thanks for the thoughts. The 2019 PAs have the Guardian series transducer mounts that retract the transducer into a protected position within the hull. Check out this short video on the Guardian series: https://www.youtube.com/watch?v=QwUL9VlFO14 I ended up calling Hobie tech support and with a email and some pictures found a solution to my question with Hobie's help. A little Dremel action and a drill bit let me install the high def, side imaging transducer in the best way on my boat. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|