Set it on top of 2 saw horses.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Help Getting Dents Out http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=66938 |
Page 1 of 1 |
| Author: | FishOvi [ Tue Jul 14, 2020 1:50 pm ] |
| Post subject: | Help Getting Dents Out |
I tied my PA12 to the roof rack and it was hot out, it created two little I dents in the bottom of the kayak. I want to let it sit on upside down in the sun, but how do I go about it? I can’t flip it over because then it will sit on the h-rails and on the steering handle. I’m worried that if I turn it on it’s side, it will then create a dent on the side. |
|
| Author: | Dr.SteelheadCatcher [ Fri Jul 17, 2020 5:37 am ] |
| Post subject: | Re: Help Getting Dents Out |
| Set it on top of 2 saw horses.
|
|
| Author: | Swfinatic [ Fri Jul 17, 2020 12:33 pm ] |
| Post subject: | Re: Help Getting Dents Out |
I've seen a video where they turned the kayak upside down and poured boiling water over the affected or dented area. The boiling water is hot enough to soften the plastic so it will return to it's originally formed shape but not hot enough to burn through the plastic. |
|
| Author: | mmiller [ Fri Jul 17, 2020 1:20 pm ] |
| Post subject: | Re: Help Getting Dents Out |
Dent removal FAQ: https://www.hobie.com/forums/viewtopic.php?f=21&t=35313 |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|