| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| 360 PA12 Drive Issue http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=67135 |
Page 1 of 1 |
| Author: | blackout68 [ Sat Aug 08, 2020 11:19 pm ] |
| Post subject: | 360 PA12 Drive Issue |
Noticed my 360 drive was acting weird today on the water and when I got it home I could hear something inside of it rattling around. When I turned the drive upside down and shook it all of these little bars started pouring out. Any idea what these could be? The PA is on a stand now and the drive seems to functioning properly but I haven't done a water test yet. 
|
|
| Author: | JMckroid [ Sat Aug 22, 2020 5:29 pm ] |
| Post subject: | Re: 360 PA12 Drive Issue |
Those look like bearing rods, Do any of the fittings feel a little looser than usual? I would have it checked out before using it, as it could cause damage if used without the bearing rods in place. |
|
| Author: | TNKayak [ Wed Aug 26, 2020 12:11 pm ] |
| Post subject: | Re: 360 PA12 Drive Issue |
JMckroid wrote: Those look like bearing rods, Do any of the fittings feel a little looser than usual? I would have it checked out before using it, as it could cause damage if used without the bearing rods in place. They look like the bearing rods that are located inside the middle shaft that holds the pedal assembly together. I hope that makes sense. |
|
| Author: | mmiller [ Wed Aug 26, 2020 12:26 pm ] |
| Post subject: | Re: 360 PA12 Drive Issue |
Warranty for sure. There were some changes early on to prevent bearings from coming out. Don't recall the reason they would. Maybe global adjustment was loose? |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|