| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| HCE Shroud anchor pins http://www.hobie.com/au/en/forums/viewtopic.php?f=9&t=12953 |
Page 1 of 1 |
| Author: | Karl Brogger [ Wed Jul 01, 2009 7:01 pm ] |
| Post subject: | HCE Shroud anchor pins |
Does anyone know the size and pitch of threads? The thread gauge I used ,(Matco) says its 1.5mm, but a 11mm die seems sloppy while a 10mm die will not thread on. Also, a 7/16-20 die threads on, yet the 20 tpi gauge does not fit. I'd chase a tap down the hole, but the threads are full of silicone and I'm concerned I'd mess up the threads not being able to feel how easily it goes in. |
|
| Author: | Rick Buchanan [ Thu Jul 02, 2009 9:48 am ] |
| Post subject: | Re: HCE Shroud anchor pins |
Parlez-vous français ? Good luck Karl |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|