| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Spin poles? http://www.hobie.com/au/en/forums/viewtopic.php?f=9&t=13087 |
Page 1 of 1 |
| Author: | Karl Brogger [ Wed Jul 15, 2009 5:15 pm ] |
| Post subject: | Spin poles? |
Does anyone know if the HC spin poles are double walled, or is there just an extra piece near the end to support the rivets for the block at the end of the pole? |
|
| Author: | Dan DeLave [ Wed Jul 15, 2009 6:16 pm ] |
| Post subject: | Re: Spin poles? |
Just at the end. The piece is about 4 - 5 inches long. |
|
| Author: | Karl Brogger [ Fri Jul 17, 2009 7:14 pm ] |
| Post subject: | Re: Spin poles? |
Thanks Dan, I was going to buy some aluminum tubing to make my own. Didn't know if I needed to go with a thicker wall or what. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|