| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| pressurizing hull during delamination repair??? http://www.hobie.com/au/en/forums/viewtopic.php?f=9&t=1863 |
Page 1 of 1 |
| Author: | Russ B [ Sun May 29, 2005 7:03 am ] |
| Post subject: | pressurizing hull during delamination repair??? |
Has anyone thought about or tried pressurizing the hull to push the inner layer of glass and foam back outward against the outer layer??? |
|
| Author: | mmiller [ Sun May 29, 2005 6:23 pm ] |
| Post subject: | Pressure? |
Pressure? Sounds interesting. May push resin out though. |
|
| Author: | Russ B [ Mon May 30, 2005 10:13 pm ] |
| Post subject: | |
My thoughts were to do the usual "drill and fill", tape off the holes and seal the vents, and then add a few pounds of pressure to the hulls while the epoxy sets. I may try it if I can find some delaminated hulls to experiment with. I looked at a boat today that would be a good candidate, but unfortunately the owner wanted too much money for her. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|