| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| 1984 holder 12 cover http://www.hobie.com/au/en/forums/viewtopic.php?f=9&t=26676 |
Page 1 of 1 |
| Author: | holder12 [ Tue Jun 22, 2010 9:49 am ] |
| Post subject: | 1984 holder 12 cover |
Does anyone know of a effective (cover filled with water) way to raise the boat cover on a holder 12. The cover is heavy canvas and I am trying to figure out how to raise the cover so water will drain over the edge of the boat. I just purchased this boat. |
|
| Author: | mmiller [ Tue Jun 22, 2010 10:33 am ] |
| Post subject: | Re: 1984 holder 12 cover |
2x4 along the centerline under the cover? Pull the material tight to make a tent. |
|
| Author: | ronholm [ Tue Jun 22, 2010 3:23 pm ] |
| Post subject: | Re: 1984 holder 12 cover |
1 inch PVC pipe.. Bend it into shape and tie it down.. Or use a heat gun and bend some hoops and then build a PVC base so that the hoops hold their shape.. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|