Hi could someone tell me the exact measurement of a H18 tiller crossbar? and how far in the end holes for the extending castings should be?
Matt?
My hobie is 1981 dont know if that affects anything
Thanks
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Home made H18 tiller crossbar http://www.hobie.com/au/en/forums/viewtopic.php?f=9&t=3635 |
Page 1 of 1 |
| Author: | splash [ Sat May 20, 2006 5:08 am ] |
| Post subject: | Home made H18 tiller crossbar |
Hi could someone tell me the exact measurement of a H18 tiller crossbar? and how far in the end holes for the extending castings should be? Matt?
My hobie is 1981 dont know if that affects anything Thanks |
|
| Author: | mmiller [ Mon May 22, 2006 4:05 pm ] |
| Post subject: | Tiller X Bar |
The tube should be about 76". The extenders on each side are about an inch minimum to about 3 inches extended on each end. Just put the rudders down. Measure to get them parallel. That is the needed length. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|