Lance Cleats
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| what cleat to use for the jib furller line http://www.hobie.com/au/en/forums/viewtopic.php?f=9&t=3986 |
Page 1 of 1 |
| Author: | splash [ Sun Jun 25, 2006 8:00 am ] |
| Post subject: | what cleat to use for the jib furller line |
I want to add a new cleat to the front cross bar on the top, port side to make it more accesible, what type of cleats would you recomend?? Thanks |
|
| Author: | mmiller [ Sun Jun 25, 2006 10:09 am ] |
| Post subject: | Cleat |
Something like the small Lance Cleat. That has a small spring loaded jaw. Once the line is released it will not get hug up. The V jaw cleats always require you to guide the line out so it will not cleat itself. |
|
| Author: | ncmbm [ Mon Jun 26, 2006 1:45 pm ] |
| Post subject: | |
Small spinlock would work nicely. They make one with a swivel base as well. Put a stop ball on the end to keep it in the cleat and its fool proof. |
|
| Author: | splash [ Mon Jun 26, 2006 2:55 pm ] |
| Post subject: | ncmbm could you post a link of that hardware |
ncmbm could you post a link of that hardware Thanks |
|
| Author: | ncmbm [ Tue Jun 27, 2006 10:04 am ] |
| Post subject: | |
Layline.com, They are a sailboat company in Raleigh, NC. Mostly cater to mono slugs. Look in spinnaker running gear section. I have used these for spin halyards in the past, work great. |
|
| Author: | mmiller [ Tue Jun 27, 2006 11:37 am ] |
| Post subject: | Lance Cleats |
Lance Cleats
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|