| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Holder 12 rudder/tiller http://www.hobie.com/au/en/forums/viewtopic.php?f=9&t=51594 |
Page 1 of 1 |
| Author: | jbellnews [ Tue Jun 10, 2014 12:26 pm ] |
| Post subject: | Holder 12 rudder/tiller |
I am desperately searching for a Holder 12 rudder/tiller assembly and would greatly appreciate suggestions from anyone as to how to find one! Thanks much, Jeff Bell [email protected] |
|
| Author: | srm [ Tue Jun 10, 2014 2:26 pm ] |
| Post subject: | Re: Holder 12 rudder/tiller |
I think your best bet is probably to adapt a Laser rudder. They are much more readily available and are very similar so should work with pretty minor modification. You would likely just need to swap out the pintles/gudgeons. You might also need to play with the rake a little to get the helm to balance but I doubt you would need to adjust it very much. sm |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|