Hello?
Bueller?
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Jib Furler Tune Up Questions http://www.hobie.com/au/en/forums/viewtopic.php?f=9&t=64610 |
Page 1 of 1 |
| Author: | Cattywampus2012 [ Fri Apr 26, 2019 9:57 am ] |
| Post subject: | Jib Furler Tune Up Questions |
Tuning up the job furler on my 2012 Getaway (with the Hobie kit) and had a couple questions. 1. My furler bridle yoke and furler sleeve seem to be permanently attached to one and other - and not separate as the parts diagrams show. Do I need to disengage them from one and other - if so any ideas as to how - or just leave them as is? 2. Aside from the grease that comes on the new ball bearings included in the kit, is any lubrication needed for the furler? Thanks Much! Best Regards, Eric |
|
| Author: | Cattywampus2012 [ Sat Apr 27, 2019 10:00 am ] |
| Post subject: | Re: Jib Furler Tune Up Questions |
Hello? Bueller?
|
|
| Author: | mmiller [ Mon Apr 29, 2019 1:51 pm ] |
| Post subject: | Re: Jib Furler Tune Up Questions |
The anti-seize lube used on the bearings should be enough. No need to pull the yoke from the sleeve I'd think. |
|
| Author: | Cattywampus2012 [ Thu May 02, 2019 7:23 am ] |
| Post subject: | Re: Jib Furler Tune Up Questions |
Thanks Matt! Best Regards |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|