Hobie Forums
http://www.hobie.com/au/en/forums/

Hobie Holder 12 rudder clip/retainer
http://www.hobie.com/au/en/forums/viewtopic.php?f=9&t=66982		 Page 1 of 1
Author:  robertwa [ Mon Jul 20, 2020 7:39 am ]
Post subject:  Hobie Holder 12 rudder clip/retainer
I recently purchased an old Holder 12. It looks like it is missing the upper rudder pin clip as there is nothing to prevent the rudder from lifting out of the fittings on the transom. Anyone know what this part looks like or if it is still available? The assembly manual mentions the clip but the picture is too blurry to make it out.
Thanks,
Rob
Author:  mmiller [ Mon Jul 20, 2020 9:35 am ]
Post subject:  Re: Hobie Holder 12 rudder clip/retainer
Not available. It was a spring plate attached to the pintle.

You could drill and install keeper wire or something.
Author:  robertwa [ Tue Oct 06, 2020 6:58 am ]
Post subject:  Re: Hobie Holder 12 rudder clip/retainer
mmiller wrote:
Not available. It was a spring plate attached to the pintle.

You could drill and install keeper wire or something.


Thanks Mike. I ended up using a simple spring cotter pin which works great
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/