| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Spinlock cleats http://www.hobie.com/au/en/forums/viewtopic.php?f=9&t=6863 |
Page 1 of 1 |
| Author: | Beachboy [ Tue May 29, 2007 5:35 pm ] |
| Post subject: | Spinlock cleats |
I just replaced my Harken cam cleats with Spinlock PXR's because my wife was having trouble uncleating the jib sheet after I had sheeted it in hard. She would fuss like crazy trying to get the sheet free while I was providing the mostly useless verbal cues on how to get the line free. These Spinlock guys have something going on. I can sheet to the max with both hands (I'm 6'3", 210) and she can get it uncleated with one snap; and the release effort is even adjustable. They retro-fit to the Harken hardware nice; strictly bolt-on. I like 'em on our H21SE. Not cheap, but worth it. |
|
| Author: | ncmbm [ Wed May 30, 2007 1:58 pm ] |
| Post subject: | |
The pxr's are nice. Quite an upgrade from the original which turned so many off. I use one for spin halyard currently. The old ones had too much plastic and jambed or broke. |
|
| Author: | Dan DeLave [ Thu May 31, 2007 8:46 am ] |
| Post subject: | |
I use the new Spinlock PXR's for a Tiger downhaul and like them alot. Have been using them for almost two years. I was asked to test them, had to send the first, kind of prototype, set back but the second set have worked great since installed. Dan |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|