Hobie Forums
http://www.hobie.com/forums/

ID of scuppers in Hobie Sport
http://www.hobie.com/forums/viewtopic.php?f=11&t=1080
Page 1 of 1

Author:  theCrw [ Wed Aug 18, 2004 9:03 pm ]
Post subject:  ID of scuppers in Hobie Sport

Hi,

What's the exact ID (inner dia) of the scupper holes in a Hobie Sport? Looking to build a custom yak carrier that slides up into the scupper holes.

Author:  gthomas [ Tue Aug 31, 2004 3:54 pm ]
Post subject: 

The ID of the scuppers which are just behind the seat are just over 1". They are actually tappered so that the bottom of the hole is larger than the top of the hole. The 1" is taken from the top where the scupper is at its smallest diameter.

Greg

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/