Thanks ADKFUN - I figured the rear hatch isn't really usable on the water as far as access, so why not put it to good use
.
| Hobie Forums http://www.hobie.com/forums/ |
|
| Power Supply Installation on a Hobie Revolution 13 http://www.hobie.com/forums/viewtopic.php?f=11&t=41916 |
Page 1 of 1 |
| Author: | Hanover_Yakker [ Mon Apr 02, 2012 8:09 am ] |
| Post subject: | Power Supply Installation on a Hobie Revolution 13 |
Some of you have seen this type of install before. I think I even saw it on this board as well as on the Texas Kayak Fishing board as well. Well, I finally got off my lazy bum and began the fish finder install on the Hobie yesterday. The first step was establishing a power source and location. The entire process took about 30 minutes and was a success. Enjoy!! Power Supply Installation on a Hobie Revolution 13 |
|
| Author: | Ricky [ Sun Apr 08, 2012 8:08 am ] |
| Post subject: | Re: Power Supply Installation on a Hobie Revolution 13 |
Nicely done! Those new large buckets are pretty handy! |
|
| Author: | Hanover_Yakker [ Mon Apr 09, 2012 5:06 am ] |
| Post subject: | Re: Power Supply Installation on a Hobie Revolution 13 |
Thanks - I know some might use other methods of securing their battery, but this one seemed obvious to me given the lack of use of the rear hatch for me. |
|
| Author: | ADKFUN [ Mon Apr 09, 2012 4:52 pm ] |
| Post subject: | Re: Power Supply Installation on a Hobie Revolution 13 |
Very cool use of the bucket! I just super velcroed the 12 v battery to the sail mast post in the well. If I get a big flood, I better hope the in line fuse works! |
|
| Author: | montedane [ Tue Apr 10, 2012 3:36 am ] |
| Post subject: | Re: Power Supply Installation on a Hobie Revolution 13 |
Hi Guys, I have just finished installing a amp & speakers to my Revo 13 as well as the eVolve kit, so I had two batteries to install. I have thought of several different ideas, but the easiest and most practical has been to cut a piece of high desiity foam and place it into the hull, lay the battery on the foam and while pressing down, slide it under the hull so that the battery is sandwiched firmly betwine the foam and the upper deck. keeps it nice & secure. Montedane. |
|
| Author: | Ricky [ Tue Apr 10, 2012 6:42 am ] |
| Post subject: | Re: Power Supply Installation on a Hobie Revolution 13 |
montedane wrote: Hi Guys, I have just finished installing a amp & speakers to my Revo 13 Nice! Got photos of the Revo? |
|
| Author: | Hanover_Yakker [ Tue Apr 10, 2012 10:19 am ] |
| Post subject: | Re: Power Supply Installation on a Hobie Revolution 13 |
Thanks ADKFUN - I figured the rear hatch isn't really usable on the water as far as access, so why not put it to good use .
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|