Hobie Forums
http://www.hobie.com/forums/

Tube for rudder cable too short
http://www.hobie.com/forums/viewtopic.php?f=11&t=46449		 Page 1 of 1
Author:  nineworlds [ Tue Feb 05, 2013 12:27 am ]
Post subject:  Tube for rudder cable too short
Hi, I just bought a Hobie Revolution 13 and I have noticed that the tube for one of the rudder cables is too short to sit in the cable holders/clips either side below the hatch. All the other tubes have at least 2 inches clearance of the clip. I think this would be a problem because the cable will wear from rubbing directly on the clip and if I don't connect it to the clip, it gets in the way when I put stuff in the hatch. Has anyone had this problem? Can you get replacements?

Image
Image
Author:  jhip [ Tue Feb 05, 2013 9:48 am ]
Post subject:  Re: Tube for rudder cable too short
I believe my revo 13 has that same issue too. Never realized that it could be an issue.
Author:  mmiller [ Tue Feb 05, 2013 10:03 am ]
Post subject:  Re: Tube for rudder cable too short
Non-issue since the line material is spectra and is not abrasive. The tubes are only routed up there to keep the ends out of the bilge.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/