Return to Hobie.com

Hobie Forums

It is currently Sat Nov 25, 2017 12:49 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Oct 15, 2017 4:17 am 
Offline
Site Rank - Deck Hand

Joined: Fri Apr 21, 2017 3:06 am
Posts: 5
The two load rack bars on this trailer are 50 inches apart and 43 inches wide. Can the hobie outback cradles be attached to the square rack bars and properly support the hull of my 10 ft outback? I was told by one dealer the cradles will only fit the hull well if they are 67 inches apart not 50 inches.

I would like to lay my Eclipse in its protective bag deck side down on top of my upright outback supported by its cradles on my trailer. Both would be strapped to the rack bars. Would this work and cause no damage to either craft?


Top
 Profile  
 
PostPosted: Mon Oct 16, 2017 9:25 am 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 11997
Location: Oceanside, California
67" is the dimension that fits the cradles best. You could add a sheet of plywood and extend the 50" support to the 67" for best results? Mount the cradles on the plywood. Might be best with the Eclipse bottom down. You could add a couple of wood (carpeted?) or foam blocks/spacers laid on the Outback rails as a then flat 2 supports for the Eclipse so you don't have any odd contact points on the Eclipse.

_________________
Matt Miller
Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group