Hobie Forums http://www.hobie.com/forums/ |
|
How to replace rudder strings on 2015 Hobi 17TPro Angler http://www.hobie.com/forums/viewtopic.php?f=11&t=62727 |
Page 1 of 1 |
Author: | lpemaverick [ Tue May 15, 2018 11:54 am ] |
Post subject: | How to replace rudder strings on 2015 Hobi 17TPro Angler |
The strings on both front and rear for the rudder had broken and were then pulled out. Not smart I know. I did search different forums but could not find one specific to the Pro Angler 17, I looked for a you tube video as well and not luck thanks in advance. |
Author: | mmiller [ Tue May 15, 2018 3:00 pm ] |
Post subject: | Re: How to replace rudder strings on 2015 Hobie 17T Pro An |
Not something we have detailed instructions for. I have a drawing showing lengths and positions of the lines: https://static.hobiecat.com/web_uploads/2018/05/15/Assembly_Pro_Angler_17_ControlLine_Steering_Sheet.PDF https://static.hobiecat.com/web_uploads/2018/05/15/Assembly_Pro_Angler_17_Control_Line_Rudder_Sheet.PDF |
Author: | WAVERIDER [ Tue May 15, 2018 6:08 pm ] |
Post subject: | Re: How to replace rudder strings on 2015 Hobi 17TPro Angl |
Stripped copper core cable of a suitable diameter as a guide maybe with a bit of fishing line glued to it, which in turn is glued to replacement cord..Maybe? |
Author: | lpemaverick [ Wed May 16, 2018 6:51 am ] |
Post subject: | Re: How to replace rudder strings on 2015 Hobi 17TPro Angl |
Matt, thank you for the drawings. Unfortunately I am still not sure how to proceed. The drawings are not that clear to me. If any one has any video or photographs or clear precise instructions on how to re-attach the rudder lines and how to thread them through the hull it would be greatly appreciated. thanks again Maverick |
Author: | Jbernier [ Wed May 16, 2018 8:47 am ] |
Post subject: | Re: How to replace rudder strings on 2015 Hobi 17TPro Angl |
Sent you an e mail - like to speak with you directly to try and help. We don't have printed instructions. (or a video) |
Author: | lpemaverick [ Wed May 16, 2018 2:24 pm ] |
Post subject: | Re: How to replace rudder strings on 2015 Hobi 17TPro Angl |
I spoke on the phone to Jacques at Hobie. He was very helpful and gave good advice. Thanks Jacques much appreciated. FYI Turns out the front t handle had been pulled off and was lost. The rigging for retracting the rudder had been pulled out of the hull. I was able to rig the rear back up but had problems fishing the cord through that small hole for the front. As Jacques recommended I used a hot knife to keep the end of the cord small. In the end I did not reconnect the front T handle as it became to difficult to thread the cord through the front hole. It could be the shortened cord, and I did release the tension. The back one is all I need for now. When I get close to a Hobie dealership I will stop in and purchase a new T handle and rigging. thanks very much Hobie great service! |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |