Return to Hobie.com
Hobie Forums
It is currently Wed Nov 25, 2020 4:00 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Fri Nov 06, 2020 8:03 am 
Offline
Site Rank - Captain

Joined: Sun Oct 18, 2009 9:09 am
Posts: 37
Problem on Hobie Revolution round twist & seal where the hatch handles on BOTH hatches (center and rear) are very loose so when carried upside down on car roof the handle just hangs down vertically. Is there a way to tighten that handle (the small roller ball & pin)?

Hatches open and close fine but am afraid in future something might actually break or hatch open by itself as that handle blows around and shakes in the wind going 70 mph down the highway. I keep putting put tape over the handle when car topping but soon will run out of tape or patience to do that.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group