Hobie Forums
http://www.hobie.com/forums/

Arming CO2 Life Vests
http://www.hobie.com/forums/viewtopic.php?f=11&t=67969
Page 1 of 1

Author:  yaw_string [ Fri Mar 05, 2021 9:54 pm ]
Post subject:  Arming CO2 Life Vests

For a special situation I am gonna use a non-automatic inflatable PFD. When I screw in the CO2 cylinder fairly tight there is never any pffft. It came non-attached from the vest when new. So do I take it that there is no actual cyl puncture until I pull the activator cord in an emergency? If so, it must take a hard pull. Of course I have waded thru all applicable instructions and videos. tks

Author:  stringy [ Sat Mar 06, 2021 1:30 pm ]
Post subject:  Re: Arming CO2 Life Vests

Yes, the actuator punctures the cylinder. You need to make sure the cylinder is screwed tightly into the mechanism.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/