| Hobie Forums http://www.hobie.com/forums/ |
|
| How to remove this? http://www.hobie.com/forums/viewtopic.php?f=11&t=70111 |
Page 1 of 1 |
| Author: | Mahi [ Fri Jul 29, 2022 9:05 pm ] |
| Post subject: | How to remove this? |
This cord has loosened up some over the years and no longer retains the paddle properly. I need to remove one of the round black retainers (not sure what the proper name for it is), so I can tighten the cord a little. Tried unscrewing with no joy, but didn't want to put too much force on incase that's not how it comes out I don't want to break it. Anyone know how to get these out? 
|
|
| Author: | plfinch [ Fri Jul 29, 2022 9:51 pm ] |
| Post subject: | Re: How to remove this? |
Take a look here... https://www.hobie.com/forums/viewtopic.php?f=71&t=68514 Peter |
|
| Author: | Mahi [ Fri Jul 29, 2022 10:56 pm ] |
| Post subject: | Re: How to remove this? |
Oh thanks plfinch, very helpful. I will try it tomorrow 
|
|
| Author: | plfinch [ Fri Jul 29, 2022 11:31 pm ] |
| Post subject: | Re: How to remove this? |
Also take a look at the last 4 or 5 posts in this thread. https://www.hobie.com/forums/viewtopic.php?f=11&t=66026 Peter |
|
| Author: | Mahi [ Sat Jul 30, 2022 6:05 pm ] |
| Post subject: | Re: How to remove this? |
Thanks for all that plfinch, with the knowledge it unscrews I tried my fishing pliers and found they fit the little unscrewing slots perfectly, so it was a simple job to put them in, turn, and it unscrewed. Then as per the second pic I tied a second knot, then after that cut the end knot off and sealed with a burner. Re assembled and now the paddle is held good and tight. A 5 minute job  
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|