|ATR v3 paint/finish problem
|Page 1 of 1|
|Author:||zaco77 [ Sat Sep 10, 2016 4:48 pm ]|
|Post subject:||ATR v3 paint/finish problem|
I bought my first Hobie SUP ATR v3 in June. I love this board, I use it in the rivers and bays where I live. I unfortunately have an issue with the paint/finish. I used suction cups for the deck rigging and the paint/finish lifted off the board. The shop I bought the board from contacted Hobie for warranty and Hobie said it is not covered. I am a bit confused as the suction cups I used specifically said for smooth fiberglass finish sufaces which is what the ATR series is. Has anyone experienced this? I sure wish I was given some heads up about this if it was a known issue. I really don't understand why the finish would be so fragile.
|Author:||Bcastile [ Tue Sep 13, 2016 9:38 am ]|
|Post subject:||Re: ATR v3 paint/finish problem|
I have never seen suction cup damage before on a SUP. It is a painted surface though so a strong suction with a lot of force against it could damage or at least mark the paint I suppose.
|Page 1 of 1||All times are UTC - 8 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group