Hobie Forums http://www.hobie.com/forums/ |
|
Sealing inspection ports http://www.hobie.com/forums/viewtopic.php?f=13&t=42374 |
Page 1 of 1 |
Author: | JSWoerner [ Thu Apr 26, 2012 3:27 am ] |
Post subject: | Sealing inspection ports |
My boat has the factory ports as well as 4" ports aft of the dagger wells. Lately the port hull has been draining a cup or two when we trailer out. I'm pretty sure it's been getting in where these ports meet the hull. Should I use a silicone based sealant (easy but would probably be a maintenance item) or something like epoxy or polyester (more labor but more permanent)? And should I drill out the rivets and reseat them? They don't seam physically compromised but it might make a better seal. |
Author: | presto13031 [ Thu Apr 26, 2012 5:48 am ] |
Post subject: | Re: Sealing inspection ports |
Hobie sends silicone sealant with the inspection port assembly. Centralmichigansailor showed the install of his aft ports in his build here: http://www.hobiecat.com/forums/viewtopic.php?f=13&t=36064&start=15 |
Author: | SNovak [ Thu Apr 26, 2012 7:55 am ] |
Post subject: | Re: Sealing inspection ports |
presto13031 wrote: Hobie sends silicone sealant with the inspection port assembly. Centralmichigansailor showed the install of his aft ports in his build here: http://www.hobiecat.com/forums/viewtopic.php?f=13&t=36064&start=15 Make sure you follow centralmichigansailor's instructions for sealing the edge of the core. If you don't you may well wind up with a major repair job on your hands down the road... |
Author: | presto13031 [ Thu Apr 26, 2012 8:28 am ] |
Post subject: | Re: Sealing inspection ports |
SNovak wrote: presto13031 wrote: Hobie sends silicone sealant with the inspection port assembly. Centralmichigansailor showed the install of his aft ports in his build here: http://www.hobiecat.com/forums/viewtopic.php?f=13&t=36064&start=15 Make sure you follow centralmichigansailor's instructions for sealing the edge of the core. If you don't you may well wind up with a major repair job on your hands down the road... The sealing is on page 1 of that thread. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |