Return to Hobie.com
Hobie Forums
It is currently Thu Mar 28, 2024 2:54 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Sun Jun 25, 2017 5:17 am 
Offline
Site Rank - Deck Hand

Joined: Sat Jun 24, 2017 8:23 pm
Posts: 4
Have gotten a older 18 and can not find answer to 2 rigging questions . #1 The main sail halyard was removed from mast for storage. How is the correct way to install it ? inside the mast track? # 2 The mast base pin has but one clip on it . after raising the mast is this to be removed ? or if it remains I thought to buy a pin with 2 clips ? Thx good sailing


Top
 Profile  
 
PostPosted: Sun Jun 25, 2017 10:47 am 
Offline
Site Rank - Captain

Joined: Wed May 18, 2016 11:44 am
Posts: 49
Location: Traverse City, MI.
The made pin is only there to aid you in easing it the mast. Remove it once your mast is up and shrouds are connected. You can set shroud tension after you pull the pin.
Run the main halyard under the bottom pulley and inside the mast to the top, the. Over the top pulley and back down on the outside of the mast.


Top
 Profile  
 
PostPosted: Sun Jun 25, 2017 3:47 pm 
Offline
Site Rank - Deck Hand

Joined: Sat Jun 24, 2017 8:23 pm
Posts: 4
Thank You for your response , Good winds to you .


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group