First post on the Hobie Forum so here goes!
I purchased a Compass after reading through all of the posts and watching a variety of videos. Took it out on its maiden voyage a couple of days ago and have to say that I really liked the Compass. Spent 7 hours covering 7 miles in the inshore waters of Galveston's West Bay. Put her through the paces and she did well! (Posted up a more detailed report on TKF at the following link
http://www.texaskayakfisherman.com/forum/viewtopic.php?f=1&t=245600 You have to scroll down a little to find the maiden voyage write-up).
I currently have a 2015 PA-14 (which is a beast of a yak) and have previously owned a 2015 Outback. Was looking for something lighter and simpler to compliment the PA and think that the Compass fits the bill nicely.
As previously mentioned I really like the Compass and offer the following as suggestions for improvement.
(1) The seat is awesome and more comfortable than I thought it would be (with no up & down positioning). The seat design is very good but the side straps are too short. They need to be lengthened 3 inches or more to provide more range of motion.
(2) The bungee paddle keeper system works but the little round eyelet keeper (that you lash the bungee to) is located too close to the sides strap fastening cleat (the cleat that is attached to the actual kayak and that the seat strap latches into). When seated, the starboard side seat strap and cleat interfere with ones ability to quickly loop the bungee over the eyelet keeper. It is actual very difficult to perform at times. Perhaps the eyelet keeper could be re-positioned??
(3) Someone mentioned earlier that the yak needs lifting handles. This would make it so much easier to lift, transport and store but, and more importantly, you need something to grab if and when you turtle. Handles would make reentry much safe.
(4) There is no way to access the rear (interior) section of the yak. One consideration could have been to add a circular hatch in the rear but this is not possible with the current design. The recesses molded into the rear area (leading to the scuppers) are not large enough to fit in an 8" hatch (you need more flat surface area - like the area up front). My initial game plan was to add a square hatch in front of the seat and then move the the 8" hatch to the rear. I would have then placed my battery in the 8" hatch (for weight distribution as I keep a fish bag upfront). Would have also provided access to add any additional rigging (I prefer to use nuts and bolts to secure lifting handles and other items as I don't trust screws).
I really do like the Compass so great work! Just hope the feedback helps.
Thanks for the time.