Hobie Forums
http://www.hobie.com/forums/

Transducer Installation Issues
http://www.hobie.com/forums/viewtopic.php?f=138&t=65105
Page 1 of 1

Author:  wyattearp [ Sun Jul 07, 2019 2:08 pm ]
Post subject:  Transducer Installation Issues

Has anyone had issues installing the transducer through hull plug? I drilled the hole just above the scupper as shown in the video. However the plastic is very thick on one side of this hole and after about 1 turn of the nut clicks and jumps down a thread. I have tried several times and am certain it is not cross-threaded. It is a 2019 Compass.

Author:  felvic [ Mon Jul 08, 2019 10:31 pm ]
Post subject:  Re: Transducer Installation Issues

wyattearp wrote:
Has anyone had issues installing the transducer through hull plug? I drilled the hole just above the scupper as shown in the video. However the plastic is very thick on one side of this hole and after about 1 turn of the nut clicks and jumps down a thread. I have tried several times and am certain it is not cross-threaded. It is a 2019 Compass.


It's a known problem, we had many Compass like that.

The hulls often have a bump there, the only way is to sand down.
You should rather use an electric sander believe me!

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/