| Hobie Forums http://www.hobie.com/forums/ |
|
| 2021 Transducer 1” Hole Location http://www.hobie.com/forums/viewtopic.php?f=138&t=69249 |
Page 1 of 1 |
| Author: | JustMe [ Mon Nov 08, 2021 2:20 pm ] |
| Post subject: | 2021 Transducer 1” Hole Location |
It seems 2021 they removed the recessed area for the transducer cable. Where is everyone putting this now? I read somewhere that someone said it is kinda thin on the back wall. I am using seat risers for tackle boxes under the seat so if I place it where it normally went the boxes would always be hitting it. Any suggestions? |
|
| Author: | mmiller [ Mon Nov 08, 2021 4:03 pm ] |
| Post subject: | Re: 2021 Transducer 1” Hole Location |
https://media.hobie.com/digital_assets/Compass_and_Duo_Manual_Kick_Up_Rev_210715.pdf#page=17 |
|
| Author: | JustMe [ Mon Nov 08, 2021 5:10 pm ] |
| Post subject: | Re: 2021 Transducer 1” Hole Location |
While I did read that in the manual and it is wrong because it is not 2 holes at 1 3/8. I was wondering why they changed the recess for the fitting. I didn’t want it exposed to tackle box’s and was hoping for others experience of placing on the back wall or on top. |
|
| Author: | JeffersonR [ Fri May 13, 2022 6:43 pm ] |
| Post subject: | Re: 2021 Transducer 1” Hole Location |
Verify that the plastic is equal on all sides before you drill. I drilled mine in to a bubble of plastic and now have to patch the hole where the manual says to drill. 2018 Compass. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|