| Hobie Forums http://www.hobie.com/forums/ |
|
| Jib Downhaul Block http://www.hobie.com/forums/viewtopic.php?f=14&t=1956 |
Page 1 of 1 |
| Author: | Seajigger [ Thu Jun 23, 2005 1:42 pm ] |
| Post subject: | Jib Downhaul Block |
Does anyone know of a good replacement block from the jib downhaul block (Hobie 16). Mine is cracking. Maybe Harken makes something I could use (size/part #)? Thanks!!! |
|
| Author: | HC16Brazil [ Fri Jun 24, 2005 5:04 am ] |
| Post subject: | |
if you mean the ones that are hanging on the jib clew plate, I use Harken H224 micro single block on my boat, they work great and are small enough. Regards Tomas |
|
| Author: | mmiller [ Fri Jun 24, 2005 10:07 am ] |
| Post subject: | Jib halyard - downhaul block |
Jib halyard - downhaul block #11070000 |
|
| Author: | Seajigger [ Fri Jun 24, 2005 6:36 pm ] |
| Post subject: | Jib Downhaul Block |
Thanks, I am trying to replace the down haul block that is used to tighten the jib wire. The Block is located near the base of the mast and the line is secured to a cleat on the mast. |
|
| Author: | wsm [ Tue Aug 02, 2005 5:55 pm ] |
| Post subject: | Re: Jib Downhaul Block |
Seajigger wrote: Thanks, I am trying to replace the down haul block that is used to tighten the jib wire. The Block is located near the base of the mast and the line is secured to a cleat on the mast.
http://static.hobiecat.com/2010_archive/support/pdfs/partguides.pdf pg 56 part# 20710000, 4 rivets #8010181 think you have to replace the entire block |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|