Although the factory picture is this:
The best way to do it is like the 6:1 low profile mainsheet. Turn the top block 90 degrees to the bottom.
| Hobie Forums http://www.hobie.com/forums/ |
|
| Diagram of down haul feed http://www.hobie.com/forums/viewtopic.php?f=14&t=42512 |
Page 1 of 1 |
| Author: | culpyy [ Thu May 03, 2012 2:38 pm ] |
| Post subject: | Diagram of down haul feed |
Does anyone have a picture of the correct way to thread a line through a 6:1 down haul? Thanks! |
|
| Author: | MBounds [ Fri May 04, 2012 12:19 pm ] |
| Post subject: | Re: Diagram of down haul feed |
Although the factory picture is this: The best way to do it is like the 6:1 low profile mainsheet. Turn the top block 90 degrees to the bottom.
|
|
| Author: | ronholm [ Fri May 04, 2012 12:28 pm ] |
| Post subject: | Re: Diagram of down haul feed |
I just went through the same debate with my on mine. I ended up doing it like the factory picture because I didn't come up with enough room at the goosneck for the upper block to be able to twist 90 degrees.. Although there is no need for it to be able to go block to block... Was I missing something? |
|
| Author: | culpyy [ Sun May 06, 2012 11:14 pm ] |
| Post subject: | Re: Diagram of down haul feed |
Beautiful! Thanks! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|