Hobie Forums
http://www.hobie.com/forums/

Aussie jib install
http://www.hobie.com/forums/viewtopic.php?f=14&t=43194
Page 1 of 1

Author:  wpbeyes [ Fri Jun 08, 2012 10:37 am ]
Post subject:  Aussie jib install

I'm thinking of going with this aussie set up. Is the jib different on an aussie halyard system? Is the cut of a new jib the same as they were in 1989?

Author:  hobie1616 [ Fri Jun 08, 2012 7:27 pm ]
Post subject:  Re: Aussie jib install

Jib remains the same. With the Aussie system the 3:1 purchase moves to between the head of the jib and the tang. Stock 3:1 is done at the base of the mast.

Author:  jonh [ Sat Jun 09, 2012 6:22 am ]
Post subject:  Re: Aussie jib install

Note that you'll also need more line... just an FYI

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/