Hobie Forums http://www.hobie.com/forums/ |
|
Removing tiller arm from upper casting http://www.hobie.com/forums/viewtopic.php?f=14&t=48822 |
Page 1 of 1 |
Author: | jim-doty [ Thu Aug 08, 2013 7:05 am ] |
Post subject: | Removing tiller arm from upper casting |
One of my tiller arms is bent and I am trying to replace it. I have the rivets out but still can't get the arm out of the casting. Any suggestions? |
Author: | jim-doty [ Thu Aug 08, 2013 7:30 am ] |
Post subject: | Re: Removing tiller arm from upper casting |
Never mind, I got it. Rested upper casting on a vise with tiller arm between jaws but not tightened down. Cut a piece of wooden dowel about the same diameter as the tiller tube, put that on the back side of the tube and gave it a few good whacks. Popped right out! |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |