Return to Hobie.com

Hobie Forums

It is currently Fri May 25, 2018 3:45 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Thu Feb 01, 2018 8:47 am 
Offline
Site Rank - Deck Hand

Joined: Sun Sep 24, 2017 4:39 pm
Posts: 24
I know this has been a topic before, and there are several older posts about the location of the Main block hanger position. I am upgrading my '86. Can anyone give me the precise location of the hanger on the 2017/2018 boats? Latest info from Matt Miller that I have found is from 2007. According to the blue prints, location is 81.5 inches (to top rivet) aft from the front of aluminum extrusion (not including the end cap), placed at a 13 degree forward angle. Does anyone know if this is still correct? Thanks!


Top
 Profile  
 
PostPosted: Thu Feb 01, 2018 10:43 am 
Offline
Site Rank - Captain

Joined: Sat Dec 08, 2007 1:02 pm
Posts: 113
Location: Clinton Lake, Kansas
Nothing has changed

_________________
1984 H16 "Mister Rogers"
1984 H14 "Sundays"
2000 H20 "Jet"
Sheet In, Max Out


Top
 Profile  
 
PostPosted: Sun Feb 25, 2018 12:59 pm 
Offline
Site Rank - Deck Hand

Joined: Sun Sep 24, 2017 4:39 pm
Posts: 24
Just Measured the position of the block hanger on the boom of a 2017 H16. The placement of the top rivet is 82.25” on center from the forward edge of the extrusion. Not the end cap. The hanger is angled forward at 13 degrees and there is approximately 1/4” between the boom and the inside curve of the hanger.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group