| Hobie Forums http://www.hobie.com/forums/ |
|
| Main Block Hanger position revisited http://www.hobie.com/forums/viewtopic.php?f=14&t=62127 |
Page 1 of 1 |
| Author: | aus_cat16 [ Thu Feb 01, 2018 8:47 am ] |
| Post subject: | Main Block Hanger position revisited |
I know this has been a topic before, and there are several older posts about the location of the Main block hanger position. I am upgrading my '86. Can anyone give me the precise location of the hanger on the 2017/2018 boats? Latest info from Matt Miller that I have found is from 2007. According to the blue prints, location is 81.5 inches (to top rivet) aft from the front of aluminum extrusion (not including the end cap), placed at a 13 degree forward angle. Does anyone know if this is still correct? Thanks! |
|
| Author: | flatlander [ Thu Feb 01, 2018 10:43 am ] |
| Post subject: | Re: Main Block Hanger position revisited |
Nothing has changed |
|
| Author: | aus_cat16 [ Sun Feb 25, 2018 12:59 pm ] |
| Post subject: | Re: Main Block Hanger position revisited |
Just Measured the position of the block hanger on the boom of a 2017 H16. The placement of the top rivet is 82.25” on center from the forward edge of the extrusion. Not the end cap. The hanger is angled forward at 13 degrees and there is approximately 1/4” between the boom and the inside curve of the hanger. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|