Place a used chip in the cup and draw a line around the diameter.
Drill 5/6 holes within the chip diameter. They just need to be indented... not deep to work. The Teflon creeps into each hole under pressure and that locks the chip in place.
z49.jpg)
| Hobie Forums http://www.hobie.com/forums/ |
|
| Chip keeper h 16 http://www.hobie.com/forums/viewtopic.php?f=14&t=70144 |
Page 1 of 1 |
| Author: | tbhobie [ Thu Aug 04, 2022 2:40 pm ] |
| Post subject: | Chip keeper h 16 |
Can I get instructions on drilling chip keeper holes in my hobie 16 mast base? |
|
| Author: | mmiller [ Thu Aug 04, 2022 3:09 pm ] |
| Post subject: | Re: Chip keeper h 16 |
Place a used chip in the cup and draw a line around the diameter. Drill 5/6 holes within the chip diameter. They just need to be indented... not deep to work. The Teflon creeps into each hole under pressure and that locks the chip in place.
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|