Through your dealer. We can ship direct to you, but they need to order.

Installed hatch kit, good seal, however water continues to enter. After looking more closely at the forward part of the hatch, where the bungees attach the hatch to the hull, this area is the lowest point of the channel around the lid, water pools there. Best guess is it enters through the holes the bungees run thru. Going to try and seal this with marine goop and see if this improves it. The amount of water entering is not critical, but every day I end up with 2 or 3 cups of water in the hull, it’s a daily pita to vacuum it out.
I’ll update with results after I’ll give it a shot and re-test for leakage.

The template that came with my front hatch gasket was way off, too. Here's a picture of the marker line around the template compared to where the gasket actually needed to be. It was far enough off that I could tell when I first installed it that it wasn't going to match up with the lip of the front hatch. I measured everything out myself and made a new template. That template put the gasket where it is now in the picture. With the gasket there, it's super watertight. I even tried today to spray all around the edge from different angles with a water hose nozzle set to jet. Not a single drop got in. Seriously, not a drop. That does wonders for my confidence going out into rough water.