Hobie Forums http://www.hobie.com/forums/ |
|
foam blocks in outback http://www.hobie.com/forums/viewtopic.php?f=140&t=64150 |
Page 1 of 1 |
Author: | MikeyM [ Tue Jan 08, 2019 11:46 am ] |
Post subject: | foam blocks in outback |
I removed the foam blocks to make sure the inside of my kayak was clean enough to get into a SoCal lake with quagga mussel restrictions. I guess I should have made better notes as to their location for reinstallation. Is there a diagram or any info on their location. I think I got them close, but a couple of them are really really tight to get in. Thanks in advance. Mike |
Author: | mmiller [ Wed Jan 09, 2019 5:53 pm ] |
Post subject: | Re: foam blocks in outback |
On the 2019... Each of the two blocks go behind the scupper tubes. One on each side. And they zip tie to each of the tubes. |
Author: | MikeyM [ Fri Jan 11, 2019 10:11 am ] |
Post subject: | Re: foam blocks in outback |
thanks Matt, I guess I should have stated in the first place I have a 2016 Outback. There were 6 blocks I think. Mike |
Author: | mmiller [ Fri Jan 11, 2019 1:02 pm ] |
Post subject: | Re: foam blocks in outback |
Author: | MikeyM [ Sat Jan 12, 2019 8:33 am ] |
Post subject: | Re: foam blocks in outback |
Thanks Matt. Zackly what I needed |
Author: | Globbiv [ Sat Jan 12, 2019 10:15 am ] |
Post subject: | Re: foam blocks in outback |
What is their purpose? |
Author: | Dr.SteelheadCatcher [ Sun Jan 13, 2019 8:21 am ] |
Post subject: | Re: foam blocks in outback |
A few years back, flotation in the form of blocks was added to all Hobie Mirage drive kayaks in case the hull is breached/full of water |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |