Return to Hobie.com
Hobie Forums
It is currently Fri Apr 19, 2024 10:30 am

Board index » Hobie Kayaking / Fishing » Hobie Mirage Outback

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Shawn
PostPosted: Fri May 24, 2019 2:38 pm 
Offline
Site Rank - Deck Hand

Joined: Thu May 23, 2019 5:14 pm
Posts: 1
On the hull of 2019 outback right at front of mirage inset hole. There is what appears to be a brass river or brass bolt. It appears to have pulled INTO the plastic of the hull exposing a small gap. Is this normal? What should I do?
Top
 Profile  
 
mmiller
PostPosted: Tue May 28, 2019 2:55 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 15035
Location: Oceanside, California
Normal. This fitting is designed to draw more material to the area during molding. There should be a small cap on it for cosmetic reasons only.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Hobie Kayaking / Fishing » Hobie Mirage Outback

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
cron
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group