Return to Hobie.com
Hobie Forums
It is currently Thu Jun 13, 2024 10:05 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 5 posts ] 
Author Message
PostPosted: Sun Mar 24, 2024 1:14 am 
Offline
Site Rank - Admiral

Joined: Sat May 26, 2012 7:20 am
Posts: 223
Location: Bulgaria
A few ideas for attaching accessories to the Lynx seat.

https://www.youtube.com/watch?v=o-NAdzbq2aE


For the installation of H-Rails, there is no need to drill additional holes on the seat, the existing holes are used, the front bolt goes to the back, because it is longer, and in the front I put a new even longer bolt with a length of 80mm.

Image
Image

I also converted the seat from the Hobie Passport to the Hobie Lynx because I mainly use the kayak in the sea and the low center of gravity gives me a lot of extra stability.

https://www.youtube.com/watch?v=4OmVBodv1IM


Image
Image
Image


Top
 Profile  
 
PostPosted: Sun Mar 24, 2024 11:15 am 
Offline
Site Rank - Admiral

Joined: Sat May 26, 2012 7:20 am
Posts: 223
Location: Bulgaria
Image
Image
Image
Image
Image
Image


Top
 Profile  
 
PostPosted: Mon Mar 25, 2024 9:37 am 
Offline
Site Rank - Admiral

Joined: Sat May 26, 2012 7:20 am
Posts: 223
Location: Bulgaria
Today I made another improvement - an extension for the (845044) HANDLE END FITTING, so it grips the seat tube very well.

Image
Image
Image
Image
Image
Image
Image
Image
Image


Top
 Profile  
 
PostPosted: Tue Apr 02, 2024 11:16 pm 
Offline
Site Rank - Admiral

Joined: Sat May 26, 2012 7:20 am
Posts: 223
Location: Bulgaria
https://youtube.com/shorts/hN3XcDNxSLk? ... iFP1yNi_CX


Top
 Profile  
 
PostPosted: Wed Apr 03, 2024 10:34 am 
Offline
Site Rank - Old Salt

Joined: Fri Dec 01, 2006 1:38 pm
Posts: 437
That's some clever fabricating - WOW!

Since the Hobie iTrek and Compass kayaks use the same seat assembly (Hobie part #87800000), this post applies to them as well. Much more applicable to the inflatable iTreks since hull drilling isn't in any way an option.

Do you intend to sell parts or make the 3DP models available?

Peter


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group