| Hobie Forums http://www.hobie.com/forums/ |
|
| H-20 Main Traveler Replacement http://www.hobie.com/forums/viewtopic.php?f=20&t=1333 |
Page 1 of 1 |
| Author: | DHYATT [ Sun Nov 07, 2004 6:26 pm ] |
| Post subject: | H-20 Main Traveler Replacement |
Looking for suggestions on replacing the traveler on a H-20. I have ordered a replacement traveler. Do I need to remove the rivets on one of the rear crossbar end caps? |
|
| Author: | mmiller [ Sun Nov 07, 2004 11:06 pm ] |
| Post subject: | H20 Traveler |
H20 Traveler replacement. You must remove one of the track-end stops. The boat came with a "loader" typically a short plastic section of track (blue). The old car is slid onto the loader and then the traveler bearing balls are collected. Place the new car on the loader and them "load" the bearing balls into the loader and new car. Line up the loader / car with the track and slide onto the track. Fasten the end cap again. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|