Return to Hobie.com
Hobie Forums
It is currently Fri Mar 29, 2024 1:38 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 5 posts ] 
Author Message
PostPosted: Fri Dec 03, 2010 9:04 am 
Offline
Site Rank - Captain

Joined: Fri Oct 22, 2010 10:28 am
Posts: 89
I was planning on spraying gelcoat over my entire hulls but I think Im going to abandon the project... I think I will just try to buff the hulls and see what I get. The problem is I ran over one hull entirely with an orbital sander. I did not get down to the fiberglass below but the outermost glossy layer is gone and the hulls are a dull white. My main concern is if the gelcoat has been compromised and is no longer waterproof? Will I be able to make this gelcoat shiny again by polishing with compound?


Top
 Profile  
 
PostPosted: Fri Dec 03, 2010 9:44 am 
Offline
Hobie Approved Guru

Joined: Mon Jul 14, 2003 7:11 pm
Posts: 5197
Location: Detroit, MI
You can get the gloss back, but it's going to take a lot of hand work.

Wet sand through 320 / 400 / 600 / 800 / 1000 grits.
Then 3M rubbing compound, 3M Finesse-it II polishing compound, then wax to seal it up.

Gel coat isn't waterproof to begin with. It's slightly porous and needs wax to protect it from UV exposure and to seal the pores.


Top
 Profile  
 
PostPosted: Fri Dec 03, 2010 11:06 am 
Offline
Site Rank - Captain

Joined: Fri Oct 22, 2010 10:28 am
Posts: 89
I figured the gelcoat was the same composition throughout.... I have all winter to get her shined back up, thanks for the reply.

Can I wet sand with my orbital sander or should it be done by hand?


Top
 Profile  
 
PostPosted: Fri Dec 03, 2010 2:21 pm 
Offline
Hobie Approved Guru

Joined: Mon Jul 14, 2003 7:11 pm
Posts: 5197
Location: Detroit, MI
Daredevil wrote:
Can I wet sand with my orbital sander or should it be done by hand?
Only if your orbital sander is air-powered. Electric sanders used for wet sanding tend to produce shocking results.


Top
 Profile  
 
PostPosted: Fri Dec 03, 2010 4:22 pm 
Offline
Site Rank - Admiral

Joined: Tue Feb 03, 2009 6:53 am
Posts: 232
Location: Storm Lake, IA
I have used an electric sander for wet sanding and it does work pretty well......for a while..it will eventually seize up, so buy a cheap one or two...oh yea, it is probably dangerous!! keep the cord up out of puddles and use a (GFCI outlet).
FYI a GFCI outlet does not prevent shock altogether, it will only prevent deadly shock, sooo good luck!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group