| Hobie Forums http://www.hobie.com/forums/ |
|
| Removing Old Tiller Arms fromH 17 upper castings..Corroded, http://www.hobie.com/forums/viewtopic.php?f=20&t=41113 |
Page 1 of 1 |
| Author: | mtmilam [ Sun Feb 05, 2012 10:23 pm ] |
| Post subject: | Removing Old Tiller Arms fromH 17 upper castings..Corroded, |
HI, I need some tips on how to remove the tiller arms from the H 17 castings.. I got one out after putting the casting in a vice like workmate table and drilled a large hole thru the tiller where I could put a big Screw driver in and Twist the Tiller arm..It Finally came out... The Second one Won't budge and twisting broke my Table that was used as a vice. Any tricks??? Bigger Vice and Bigger lever???? Thanks Mark Milam Lousiana |
|
| Author: | presto13031 [ Mon Feb 06, 2012 10:35 am ] |
| Post subject: | Re: Removing Old Tiller Arms fromH 17 upper castings..Corrod |
mtmilam wrote: HI, I need some tips on how to remove the tiller arms from the H 17 castings.. I got one out after putting the casting in a vice like workmate table and drilled a large hole thru the tiller where I could put a big Screw driver in and Twist the Tiller arm..It Finally came out... The Second one Won't budge and twisting broke my Table that was used as a vice. Any tricks??? Bigger Vice and Bigger lever???? Thanks Mark Milam Lousiana try PB Blast. let it soak. Are you from Spring TX? |
|
| Author: | mtmilam [ Mon Feb 06, 2012 12:50 pm ] |
| Post subject: | Re: Removing Old Tiller Arms fromH 17 upper castings..Corrod |
Hi Been soaking for a day now. I'm frm Lafayette |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|