Hobie Forums http://www.hobie.com/forums/ |
|
How to drill out rivets with casings http://www.hobie.com/forums/viewtopic.php?f=20&t=43910 |
Page 1 of 1 |
Author: | divimon2000 [ Mon Jul 16, 2012 11:15 am ] |
Post subject: | How to drill out rivets with casings |
Nothing comes up in the search. Thought it would be similar, but the head comes off only to show the casing. Do I need a size up drill bit to cut the casing corner off? FYI its the SX wing rivets. Thanks. |
Author: | MBounds [ Mon Jul 16, 2012 12:22 pm ] |
Post subject: | Re: How to drill out rivets with casings |
1) Knock the rivet head(s) off (1/4" bit) 2) Remove what the rivet(s) was/were holding together 3) Knock the flange off the casing(s) (1/4" bit - gently - it's soft) 4) Drive the tail through with a 3/16" punch 5) Beer |
Author: | divimon2000 [ Tue Jul 17, 2012 7:39 am ] |
Post subject: | Re: How to drill out rivets with casings |
OK, I wasn't daring enough to use the 1/4" and stop soon enough. Then I used a mallet- not hard enough. Need hammer. All is good. BTW, my castings were installed outside of what the rivet was holding together. I think thats wrong? |
Author: | MBounds [ Wed Jul 18, 2012 8:04 pm ] |
Post subject: | Re: How to drill out rivets with casings |
divimon2000 wrote: BTW, my castings were installed outside of what the rivet was holding together. I think thats wrong? The object of the casing is to make the rivet water tight. As long as it achieves that goal, I suppose it really doesn't matter where the flange if the casing is.I have always put the flange flat against the mast extrusion before installing the tang / strap / whatever to the mast. |
Author: | divimon2000 [ Thu Jul 19, 2012 5:10 am ] |
Post subject: | Re: How to drill out rivets with casings |
Agreed, what you say seems more correct, but for some reason the rivets weren't fitting in that way. Only when I placed the casing on the outside of what was being riveted did it all fit. Oh well, It was watertight. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |