Hobie Forums
http://www.hobie.com/forums/

help with mast repair
http://www.hobie.com/forums/viewtopic.php?f=20&t=48272
Page 1 of 1

Author:  siradrad [ Mon Jul 01, 2013 5:03 pm ]
Post subject:  help with mast repair

I am restoring an 80's Hobie, the mast base rivets have torn threw the bottom of the mast. There is a small amount of aluminum reveal where the holes for the base are drill into the mast. This has torn out. What thoughts can someone provide for a repair.

Grind the mast a bit smaller perhaps or drill new holes in the mast and base piece?

Thanks.

Author:  mmiller [ Tue Jul 23, 2013 3:19 pm ]
Post subject:  Re: help with mast repair

Place rivets in new / different locations. Shortening the mast has issues due to wire lengths.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/