Hobie Forums http://www.hobie.com/forums/ |
|
Adding Traction surface tape to hull painted with Interlux http://www.hobie.com/forums/viewtopic.php?f=20&t=60034 |
Page 1 of 1 |
Author: | wanderoo222 [ Wed Mar 01, 2017 11:47 am ] |
Post subject: | Adding Traction surface tape to hull painted with Interlux |
Painting my Nacra 5.2 hull with Interlux Brightside epoxy. Can I apply Traction surface tape over the painted surface? Has anyone done This? Thank u. |
Author: | mmiller [ Wed Mar 01, 2017 12:38 pm ] |
Post subject: | Re: Adding Traction surface tape to hull painted with Interl |
How about sand in the paint? |
Author: | wanderoo222 [ Wed Mar 01, 2017 1:59 pm ] |
Post subject: | Re: Adding Traction surface tape to hull painted with Interl |
Good idea. I hadn't considered that. |
Author: | Dave Rennie [ Thu Mar 16, 2017 2:42 pm ] |
Post subject: | Re: Adding Traction surface tape to hull painted with Interl |
Interlux does make a grit to mix with the paint to create a non-skid surface, I used Kiwigrip on one Hobie and it worked out very well, I used masking tape to create outlines similar to the original Hobie layout. The kiwigrip is gentle on your butt & knees too. some tapes are like coarse sandpaper. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |